Descriptions

The fluidized bed dryer consists of air filter, heater, fluidized bed, rotating segment feeder, cyclone separator，bag dust remover, 

high press, centrifugal fan and stage for operation. According to different characters of different materials to be dried, the dryer can 

be equipped with both cyclone separator and bag dust remover or with either of them. Generally speaking, for those pellet materials

 with a large specific gravity, only a cyclone separator is needed. And for those granule or powder materials with a small specific

 gravity, a bag dust remover is needed and so is a pneumatic conveying device if possible. The dryer can also be equipped with

 a rotating segment feeder if required.

Features

This fluidized bed dryer can achieve automation and continuous drying process. It has a high drying speed and a low temperature 

and the product quality can be ensured, meeting GMP requirements. The heating resource can be steam, electricity or furnace.

Sketch of structure

Applications

This fluidized bed dryer is suitable for drying pellet or granule materials such as raw materials for medicine, tablet granules, traditional 

Chinese medicine drink granules in pharmaceutical industry; plastic resin, citric acid and other powder or granule materials in chemical

 industry .It also can dry grain, com embryo, feed etc. The most suitable diameter of the materials is 0.5-3mm.

Principle of work

Granule or pellet solid materials are fed into the fluidized bed dryer through the feeder. Filtrated clean air is heated and charged onto the 

bottom of the fluidized bed to contact with the solid materials on the distributing plate, where fluidization can be reached and the heat

 exchange between solid and air can be achieved. After being dried, the products are discharged from the outlet. Waste gas is discharged 

from the top of the fluidized bed, and powder materials are recovered by the cyclone separator or bag dust remover.

Instructions for installation

♦ Fluidized bed，cyclone separator and cloth bag dust collector should be placed on flat concrete groud without any screws on

 foundation . The air blower may be installed indoors or outdoors with foundation and screws. The plane design can be pantly 

adjusted in accordance with the building conditions.
♦ No air should leak from the air pipe system so as not to influence the drying efficiency.

Technical Parameter

 "Drying capacity':when drying sweet-sour plum crystals,it should be measured on the basis the primary moisture contents of 20% and final moisture conten ts of 5% and the air intake temperature 

at 130℃. The dry capacity of other materials should be based on different drying conditions.
"Heating energy consumption”: Steam or electric power may be used separately.